13.1.9. Removal and installation of the tank of the washing liquid
Details of installation of the tank of the washing liquid on the models equipped with faroomyvatel
Details of installation of the tank of the washing liquid on models without faroomyvatel
|
|
- Details of installation of the tank of the washing liquid are shown on illustrations to which all references which are found in the text belong.
- Remove the top cross beam of a frame (see the Section Removal and installation of the top forward cross beam of a frame).
- Disconnect an electrical wiring and hoses from pumps (5) of supply of the washing liquid and, - at the corresponding complete set, - from the liquid level sensor.
- Release a hose (3) of the refrigerator highway K/V from a clamp (4).
- On models 163.128 (ML 400 CDI) uncover also intermediate clamps of fastening of hoses to the assembly block of safety locks/relay.
- Release the heat exchanger of a cooler (10) from the lower landing plugs.
- By means of the assistant raise a cooler (10), turn out a bolt (2), release the tank of the washing liquid (1) from landing plugs (6), take away it inside and, having pulled up, take from a motive compartment.
- Installation is made upside-down, - track completeness of landing of the tank (1) in plugs (6) and reliability of a zashchelkivaniye of a side clamp.
|
|