12.2.4. Removal and installation of the lower cross lever

Details of installation of the lower cross lever of a back suspension bracket

6j — Rack-mount assembly
7a — the Lower spherical support
94 — Nizhny Novgorod the cross lever
125a — the Bearing with a nut
125b — the Bearing
125 — the Remote plug

125d — the Bearing
125e — the Bearing
125f — the Bolt
And — Version 1
In — Version 2


 PERFORMANCE ORDER

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

  1. Details of installation of the lower cross lever of a back suspension bracket are shown on an illustration to which all references which are found in the text belong.
  2. Remove back wheels.
  3. Disconnect rack-mount assembly (6j) from the lower cross lever (94).
  4. Remove the bearing with a nut (125a) and take from the lever (94) a bolt (125f).
  5. Give fixing nuts, take axial bolts, separate the lever (94) from a stretcher and develop it down on a spherical support (7a).
  6. In case of need holding a spherical head by means of TORX key, release a support (7a) from the lever (94).
  7. Remove lower are cross the lever (94).
  8. Estimate a condition of a spherical support (7a) (see the Section Check of a Condition of Spherical Support of a Rotary Fist), in case of need remove a support (use an extractor) and make its replacement.
  9. Installation is made upside-down, - track that when landing the lever and tightening the bearing with a nut (125a) assembly of the back bridge settled down strictly horizontally.