12.1.7. Check of a condition of spherical support of a rotary fist
Check of the top spherical support without removal from the car
|
|
- Illustrative material on check of the top spherical support without removal from the car is presented on an illustration to which all references which are found in the text belong.
- Car front also establish to Poddomkratta it on props.
- Estimate a boot condition (8f) of a support (8), - existence of cuts and cracks is inadmissible.
- Having firmly pulled the corresponding wheel (shooter), make sure of lack of a side play in a support (8), - in case of need replace the top cross lever (6) (see the Section Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator).
|
|
Lower support
Visually estimate a support boot condition, in case of need make its replacement.
With removal from the car
|
|
Check of the removed top spherical support |
|
|
Check of the removed lower spherical support |
|
|
- Illustrative material on check of spherical support without removal from the car is presented on illustrations to which all references which are found in the text belong.
- By means of an extractor remove a spherical support (6/7).
- Having used a tube about 150 mm long as a collar, estimate smoothness of the course of a spherical finger of a support in all directions, - in case of identification of failures of resistance or signs of a zakusyvaniye replace a defective component.
- Estimate a boot condition, - existence of cuts and cracks is inadmissible.
- Establish a support on the regular place.
|
|