7.1.7. Removal and installation of the sensor of provision of a bent shaft (CKP)

Details of installation of the CKP (L5) sensor of the engine of a series 111

Details of installation of the CKP (L5) sensor of engines of series 112 and 113


 PERFORMANCE ORDER

  1. Details of installation of the CKP sensor of petrol engines are shown on illustrations, in case of need remove the air cleaner.
  2. After replacement of the CKP sensor it is necessary to make a reinitsialization of the module of management with use of the special diagnostic equipment, - it is the most reasonable to charge implementation of this procedure to specialists of car service.

Diesel models

Details of installation of the CKP sensor of the engine of a series 612

1 — the Contact socket
2 — the Bolt

L5 — the CKP Sensor


 PERFORMANCE ORDER

  1. Details of installation of the CKP sensor of the diesel engine of a series 612 are shown on an illustration to which all references which are found in the text belong
  2. The car also establish to Poddomkratta it on props.
  3. Remove the lower section of a noise isolation.
  4. Disunite the contact socket (1).
  5. Turn out a fixing bolt (2) and remove the CKP (L5) sensor.
  6. Installation is made upside-down.