14.8.6. Removal and installation of switches of the electric drive of adjustment of front seats

Details of installation of switches of the electric drive of adjustment of a seat

1 — the Front seat
2 — the Forward panel of finishing
3 — Screws
4 — the Side panel of finishing
5 — Screws
8 — Lock uvulas

S22 — the Switch of adjustment of a driver's seat
S22x1 — the Contact socket of an electrical wiring of the switch
S23 — the Switch of adjustment of a passenger seat
S23x1 — the Contact socket of an electrical wiring of the switch
X54/1 — the Contact socket of an electrical wiring of the ESA regulator


 PERFORMANCE ORDER

  1. Details of installation of switches of the electric drive of adjustment of a front seat are shown on an illustration to which all references which are found in the text belong.
  2. Turn out screws (3) fastenings of the forward panel (2) finishings of a frame of a seat.
  3. Delay the panel (2) approximately on 1 cm down and remove it, having given forward, - do not forget to release an electrical wiring plait from clamps on the back panel of the party.
  4. Turn out fixing screws (5) and remove the side panel (4) finishings of a frame of a seat.
  5. Disunite the contact socket of an electrical wiring (S22x1 or S23x1) from the corresponding switch (S22 or S23).
  6. Disunite the contact socket (X54/1) of an electrical wiring of the regulator of provision of a seat (ESA).
  7. Having squeezed lock uvulas (8), release the corresponding switch (S22 or S23) from the finishing panel (from the inside of the last).
  8. Installation is made upside-down.